124
en | Troubleshooting
AutoDome Easy II
F.01U.164.478 | 2.0 | 2010.02
Installation Manual
Bosch Security Systems, Inc.
Camera moves when
moving other
cameras
–
Check that the camera address is properly set
(
ON
-
997
-
ENTER
). If the camera address is not
set, the AutoDome Easy II responds to control
commands to any camera on the system.
If camera address is not set, then:
–
Invoke the
FastAddress Menu
to assign a
camera address (
ON
-
998
-
ENTER
).
Cannot access user
settings
–
Enter the unlock command
OFF
-
90
-
ENTER
.
(Commands automatically lock in 30 minutes.)
Then,
–
Enter
ON
-46-
ENTER
.
Picture is dark
–
Check that the Gain Control is set to
AUTO
(
ON
-
43
-
ENTER
).
If O.K., then:
–
Check that the Auto Iris Level is set to the
appropriate level (
ON
-
11
-
ENTER
).
If O.K., then:
–
Check that the video coax is terminated with
75 ohm only at the head end (double
termination causes dark video).
If O.K., then:
–
Go to the
Camera Setup Menu
and increase
the Pre-Compensation setting.
If O.K., then:
–
Check that the camera lens cover is removed.
If O.K., then:
–
Check that the maximum coax distance has not
been exceeded.
If O.K., then:
–
Restore all camera settings (
ON
-
40
-
ENTER
).
