5.4.2
To remove door latch
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers or
wrench.
1.
Remove toe kick
– section 5.1.4.1
2.
Disconnect & pull out dishwasher
– section 5.1.4.2.
3. Remove frame stiffener by removing (4) T-20 Torx four
screws
(below left)
.
4. Remove door latch by removing (1) T-20 screw and
rotating the latch up away from the tank tabs
(below center
and right)
.
5.5
Water valves
Access the water valve from the front of
the dishwasher base by removing the toe
kick.
5.5.1
To remove water valve
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers
.
1.
Remove outer door
– section 5.1.2.1.
2.
Remove toe kick
– section 5.1.4.1
3. Remove base insulation (on models with insulation).
4. Turn off water and disconnect water line
(below left)
.
5. Turn off electricity and disconnect electric supply by
unplugging power cord or disconnecting wire harness /
loosening strain relief
(below center & right)
.
6. Remove two (2) T-20 Torx screws from water valve
(below
left)
.
7. Disconnect wire harness from water valve
(below center)
.
8. Pull valve out from dishwasher, loosen hose clamp and
disconnect water hose from rear of valve
(below right)
.
Remove any water from sump & base.
702_58300000130262_ara_en_c
Page 29 of 50
