TIP:
Outer doors with foam door guards don’t need the door
guards removed unless the outer door is being replaced.
3. To remove handles from outer doors, remove two (2)
screws and washers from the inside of the door.
5.1.2.2
To remove fascia panel
Fascia panels and outer doors are both removed by removing
inner door screws. For most dishwashers, the top four (4) screws
hold the fascia panel.
Tools needed: T-20 Torx screwdriver
.
1. Remove fascia panel by removing six (6) long fascia panel
screws from top of inner door
(next column, left)
. If
needed, remove outer door first (section 5.2.1.1).
2. Lift fascia panel out from door. Be careful to not damage
wire harnesses. The long six (6) fascia screws are
different than the short six (6) outer door screws, so don’t
mix screws when removing both fascia panel and outer
door
(below right)
.
5.1.3
Side and bottom front access
5.1.3.1 Left side access
The water inlet system, condensation (breather) hose, water inlet
hose and internal drain hose are accessible from the left side.
1
4
3
2
1. Condensation tube
2. Drain hose (with high loop)
3. Water inlet hose
4. Water inlet
702_58300000130262_ara_en_c
Page 21 of 50
