BIKES – OWNER’S MANUAL
36
5.4. HEART RATE TEST
The heart rate test allows you to determine if the heart rate systems (chest strap and hand grips) are working properly and
that the computer is displaying your heart rate signal during a program.
1. Enter the DIAGNOSTICS Menu, select HEART RATE TEST and press the
JustGo
TM
to validate.
2. Attach your heart rate chest strap. If a heart rate chest strap signal is detected it will be displayed in the bottom left-hand
side of the screen. The contact heart rate value will be displayed in the bottom center of the screen. You do not have to
be walking on the belt to do this test; simply stand near the computer. In a few seconds, your actual heart rate will be
displayed on-screen. Do the same for the hand grip system; put your hands on the metal plates and wait for five (5) to
eight (8) seconds.
3. Press the
STOP
key to terminate this test.
5.5. SOUND TEST
The sound test will cause the beeper to sound.
1. Enter the DIAGNOSTICS Menu, select SOUND TEST and press the
JustGo
TM
key to accept.
2. Listen for a series of beeps.
3. Press any key to terminate the test.
5.6. CLOCK TEST
The CLOCK TEST allows you to ver
ify the clock chip and circuitry.
1. Enter the DIAGNOSTICS Menu, select CLOCK TEST and press the
JustGo
TM
key to accept.
2. The current time is displayed at the top of the screen and AM or PM is displayed at the bottom of the screen.
3. Press the
JustGo
TM
key to see the current date in the format of YYYY_MM_DD.
4. Press the STOP key to terminate the test.
5.7. USB PORT TEST
The USB test will check to see that the USB connector is functioning correctly.
1. Place an empty USB Key (Flash Drive) into the port.
2. Enter the DIAGNOSTICS Menu, select USB PORT TEST and press the
JustGo
TM
key to accept.
3. If no USB Key is in the connector or if the connector is not reading the USB key the screen will display USB TEST
FAILED.
4. Press the STOP key to terminate the test.
5.8 BRAKE TEST
The Brake test will check the K2 Electromagnetic Resistance System is operating correctly.
1. Enter the DIAGNOSTICS Menu, select BRAKE TEST and press the
JustGo
TM
key to accept.
2. Level 1 will be displayed on the right hand side of the screen.
3. While pedaling increase the level all the way to Level 20 ensuring that the resistance increases with the value.
4. Press the STOP key to terminate the test.
5.9 SPEED SENSOR TEST
The speed sensor test allows you to see whether your speed sensor circuit is functional or not.
1. In the DIAGNOSTICS Menu, select the SPEED SENSOR TEST and press the
JustGo
TM
key to accept.
2. Pedal and look at the display that will indicate the actual speed. If the result is good, the message “ TEST OK” will
appear.
3. If the test fails, the message “TEST FAILED” will appear.
• Check If your speed sensor is connected to the electronic card.
4. Press the
STOP
key to terminate the test.
Summary of Contents for R6X
Page 2: ......
