6
Service Procedures
37
Blue Seal Evolution Series Gas Convection Ranges
© Copyright Moffat Ltd. 21 June 2016
Amendment 13
6.5.5 Oven Pilot Thermocouple
1.
Withdraw oven pilot burner from front of oven (refer
section 6.5.3).
2.
Unscrew thermocouple from the pilot burner assembly.
(refer 6.5.3).
3.
Remove the oven control panel (refer 6.1.2) and the right
hand side panel.
4.
Disconnect thermocouple from rear of oven gas control.
5.
Remove the thermocouple, replace and re-assemble in
reverse order.
NOTE: When screwing thermocouple back into gas
control, once threaded up, tighten up another ¼
turn only. Do not over-tighten.
Thermocouple
Pilot Gas Supply
Injector Gas Line
Figure 6.5.5a
Figure 6.5.5b
Thermocouple
6.5.6 Oven
Fan
1.
Remove all racks and trays from oven, and remove right
hand rack support.
2.
Loosen grub screw locking fan onto shaft.
3.
Using a gear puller if required, remove the fan from the
shaft.
4.
Replace and re-assemble in reverse order.
Grub Screw
Figure 6.5.6
1.
Remove the oven fan (refer 6.5.6).
2.
Remove the right hand side panel from the unit.
3.
Cut cable ties and remove motor wires from capacitor,
terminal block, and earth stud.
4.
Undo the three motor mounting bolts.
5.
Replace motor and re-assemble in reverse order.
NOTE:
Always replace the motor mounting bushes when
replacing the motor.
6.5.7 Oven Fan Motor
Figure 6.5.7
Three Bolts
Summary of Contents for Evolution Series
Page 94: ......
