Blue Coat SG810 series, Installation Manual

Page: 78 / 110

P/N 231-02941 SG810 Installation Guide page 78
• In a Firefox browser, select
Tools > Options > Advanced > Network >
Connections.
Click
Settings
and clear
Manual
or
Automatic Proxy Configuration
if one of them is selected (select
Direct Connection to the Internet
).
• In a Netscape Communicator browser, select
Edit>Preferences>Advanced>Proxies
and deselect
Manual
or
Automatic Proxy
Configuration
if one of them is selected (select
Direct Connection to the
Internet
).
• Restore the appliance to its factory defaults (the Initial Configuration page is
not accessible to an appliance that has already been configured). See
“Resetting the SG810 to Factory Defaults” on page 78.
• Use another method such as the serial console.
Resetting the SG810 to Factory Defaults
When the SG810 is powered on and has booted up, but an initial configuration
has not yet been performed, the Power LED flashes green and amber. If the Power
LED is solid green, the initial configuration has already been performed. If you
did not perform an initial configuration, but the Power LED is solid green, reset
the appliance to its factory defaults. Also reset the appliance if you cannot connect
to the Initial Configuration page through your browser. The initial configuration
Web page is accessible only to an appliance that has not been configured.
You can reset the SG810 to factory defaults by:
• Holding down the left arrow key on the front panel for 5 seconds. The
appliance will be reinitalized, and you will need to configure the SG510 again.
• Using the Management Console or the CLI.
Hold this key
down for 5
seconds.