Blue Coat SG810 series, Installation Manual

Page: 15 / 110

P/N 231-02941 SG810 Installation Guide page 15
4
When the disk-drive carrier meets the SG810 frame, firmly press the edges of
the disk drive carrier into the drive slot. Then, push the lever in towards the
button until the handle latches on the button SG810, seating the drive firmly
in place.
Note: To remove a disk drive, press the button on the right side of the
disk-drive carrier to release the lever. Pull the lever towards you to
slide the carrier out of the slot.
5
Repeat steps 2 to 4 to install the number of disk drives you purchased in drive
slots 2 through 4.
Important: Before you move or transport an SG810 chassis, you must
remove all the disk drives from the system. Package the drives
separately in ESD protective materials and place them back into
the accessory kit or equivalent packaging to prevent damage. If
you do not follow this guideline, hard drive failure might occur.