Blue Coat SG810 series, Installation Manual

Page: 25 / 110

P/N 231-02941 SG810 Installation Guide page 25
Edit Mode From Configuration mode, use the
Up
or
Down
arrow button
until the parameter you want to configure is displayed,
then press the
Enter
button to go to Edit mode for that
parameter (for a first-time configuration, you must begin
with the first displayed parameter—IP address).
To configure the parameter, use the
Left
and
Right
arrow
buttons to position the cursor over a character you want to
change, then use the
Up
and
Down
arrow buttons to cycle
through the characters. When the entire parameter is
configured correctly, press the
Enter
button to save the
setting and return to Configuration mode.
Important: The system automatically exits Edit mode,
without saving parameter configurations, if
no activity is detected for 20 seconds.
In Edit mode, the cursor is a blinking box in the LCD.