Blue Coat SG810 series, Installation Manual

Page: 58 / 110

P/N 231-02941 SG810 Installation Guide page 58
Section F: Configuring a Front-Panel PIN
The front panel allows you to reconfigure the initial settings of the SG810, which
can represent a security risk. Setting a front-panel PIN limits access to authorized
personnel only.
This procedure is only available through the CLI—you cannot set a front-panel
PIN through the Management Console.
To configure a front-panel PIN:
1
Connect to the SG810 CLI and access the privileged-mode configure
commands (see
“Logging in to the SG810 CLI” on page 55).
2
From the privileged mode command prompt, change the SG810 front panel
PIN by entering one of the following commands:
SGOS#(config) security front-panel-pin PIN
-or-
SGOS#(config) security hashed-front-panel-pin hashed_PIN
where
PIN
is an unhashed PIN and
hashed_PIN
is a PIN in hashed format.
After entering one of these commands, anyone who attempts to configure the
SG810 through the front panel will be prompted to enter the PIN.