Blue Coat SG810 series, Installation Manual

Page: 49 / 110

P/N 231-02941 SG810 Installation Guide page 49
Important: Before using Director Registration in the SG810 set up console,
log in to the Director and obtain the appliance certificate for it.
The Director must have an appliance certificate and it must be
configured properly so that it can receive the registration
request from the SG810.
To configure the SG810 using Director Registration:
1
Connect the SG810 to a serial console, PC, or place it within your network,
and configure an IP address, subnet mask, and IP gateway using the serial
console or the front panel buttons. See
“Overview of First-Time Configuration”
on page 20.
2
Power on the SG810 and wait for the system to finish booting.
Figure 2-10: SG Applinace Setup Console
3
Enter information on the screen, as prompted, and press enter to proceed to
the next line
.
a.
Enter
R
using the keyboard to select Director Registration.The following
screenshot shows the SG appliance setup console.
b.
Enter the Director IP address, IP subnet mask, Director IP address, and
the IP gateway for the SG810.
c.
Enter the registration password if the SG810 does not have an appliance
certificate. This password is the
shared secret that was configured in the
Welcome to the SG Appliance Setup Console
How do you want to set up the SG appliance?
M)anual setup using the serial console
W)eb wizard (after setting network configuration using
the serial console)
R)egister with Director (registration password
required)
Choose setup mode: R