Installation
10
Optional Leg Attachment
LEG OPTIONS
Legs are available in 4" (10 cm), 6" (15 cm) āor ā25"
ā(64 cm) ālengths āāor āālow profile casters. The 6" legs
can be used on the lower section of a double
stacked unit. The 4" legs may be used with the opĆ
tional stands if additional height is required or
when mounting on a counter. The 25" legs are
used for a single oven located on the floor.
NOTE: For safety reasons, casters must not be
used with the 25" ā(64 cm) legs.
25
I
Adjustable Leg
4
I
Leg
6
I
Adjustable Leg
Low Profile Casters
Figure 6
LEG ATTACHMENT
NOTE: If low profile casters are used, install the
locking casters on the front of the oven.
The rear casters do not lock.
Be sure the
locks are set on the front casters.
1. Align the threaded stud the each leg to the bolt
āholesā locatedāāā ināā ātheā āāunit'sā bottom ācorners.
Turn the legs clockwise and tighten to the
nearest full turn.
2. Align the leg plate holes with the bolt holes.
Secure with the two 1/2" bolts provided.
3. Tip the oven up on the legs.
If ācastersā are
āused,
checkā thatā the locksā areā setā on ātheā front
casters.
4. Except for units with casters, level the oven by
screwing the adjustable feet in or out as necĆ
essary.
6" (15 cm) Legs Shown
Figure 7
