Installation
6
Location
The well planned and proper placement of your
appliance will result in long term operator conveĆ
nience and satisfactory performance.
The following clearances must be maintained beĆ
tween the unit and any combustible or nonĆcomĆ
bustible construction.
D
Oven body right side - 4" (10 cm)
D
Oven body left side - 4" (10 cm) with casters
12" (30 cm) without
casters
D
Oven body back - 4" (10 cm)
NOTE: For models with hose assemblies on the
back of the unit, the hose must be
4" (10
cm) from the wall.
If optional casters are not used, the following
clearances are recommended for service.
D
Oven body left side - 12" (30 cm)
D
Oven body back - 12" (30 cm)
Place the unit in an area which is free of drafts and
accessible for proper operation and servicing.
Keep the oven area free and clear of all combusĆ
tibles such as paper, cardboard, and flammable
liquids and solvents.
DO NOT place the oven on a curb base or seal to
the wall; either condition will prevent proper ventiĆ
lation to the blower motors. Slight unevenness can
be corrected with the adjustable legs.
Heat sources must not be located near the air
vents on the left hand side of the unit. Consult the
factory for an optional protective side heat shield
kit if a warm surface or water source is to the left
of the unit. If excessive ambient temperature or a
water source is present a heat shield must be addĆ
ed to the left hand side of the oven to protect the
unit from excessive heat or water
D
COSĆ8E heat shield
P/N R9048
D
COSĆ8EDS heat shield
P/N R9048
D
BCSĆ8E heat shield
P/N R9048
D
BCSĆ8DS heat sheild
P/N R9048
D
CNVĆ8E heat shield
P/N R9048
On all models, tripping the blower motor's thermal
overload device indicates an excessive ambient
temperature at the side of the oven. This must be
corrected to prevent permanent damage to the
oven. All motor bearings are permanently lubriĆ
cated by the manufacturer; there is no need for
additional lubrication during the operational lifeĆ
time of the motors.
