59
Type:
Common Command or Query
Command
Syntax: *SRE<ws><NRf>
Examples: *SRE 48 (Enables reporting of ESB and MAV events)
Query
Syntax: *SRE?
Response: <NR1>
f)
*STB?
- Status byte query
This query is used to read the value of the Status Byte.
Type:
Common Query
Syntax: *STB?
Response: <NR1>
The value of the Status Byte read with the *STB? query may differ from that read with the Serial Poll. Bit
6 of the STB will be set as long as a reason for requesting service exists, while bit 6 of the STB as read by
the Serial Poll is cleared by the Serial Poll.
4.12.5 Device Trigger Commands
a)
*TRG
- Trigger command
This command is analogous to the IEEE 488.1 Group Execute Trigger interface message, and has the
same effect. It is used to trigger the device to output a wave, and is accepted only when the trigger mode
is set to Trigger, Gate or Burst, and the trigger source is set to BUS.
Type:
Common Command
Syntax: *TRG
4.12.6 Stored Settings Commands
a)
*RCL
- Recall instrument state
This command is used to restore the state of the device to that stored in the specified memory location.
Arguments
Type <NRf>
Range 0 to 49. Non integer values are rounded before execution
Type:
Common Command
Syntax: *RCL<ws><NRf>
Example: *RCL 0 (Recall default state)
*RCL 49
Stored setting location 49 stores the last instrument setting before power down.
b)
*SAV
- Save instrument state
This command is used to store the current instrument state in the specified memory location.
Arguments
