23
Examples
F4:UNITS
- Selects the amplitude units: peak-to-peak, RMS or dBm.
F5:50 OHM/HI-Z
- Selects the amplitude voltage value based on the two different impedance
termination. (i.e. if connected to oscilloscope with 1Mohm, generator will display
the correct amplitude value for 1Mohm termination if HI-Z is selected)
F3:OFST -
Selects the Offset parameter. Change the offset by using the cursor keys, rotary dial or
numerical keypad. If a certain setting cannot be produced, the waveform generator will display a
“Setting Conflict” message.
F5:INTREF/EXTREF
-
Selects internal or external reference source (the external reference must be
connected to the rear panel Ref In connector).
3.6.2 MODE Key
Selects the output mode: CONT (Continuous), TRIG (Triggered), GATE (Gated), and BRST (Burst).
To select the output mode, press MODE, then press the function key that corresponds to the desired Mode menu
option, as shown:
Mode
Menu
F1: CONT
- (Continuous) - Selects continuous output.
Front Panel
Amplitude
Setting
Data Point
Value
Relative Output
Amplitude Voltage
5 Vp-p
8191
+2.5 V
5 Vp-p
4095
+1.25 V
5 Vp-p
0
0V (offset voltage)
9 Vp-p
-4095
-4.5 V
4 Vp-p
-8191
-2 V