BERTHOLD TECHNOLOGIES LB4710-050, User Manual

Page: 213 / 227

Chapter 6 Error Messages
Mini-Switch LB 471
68
Error
number
Error
sub-code
Designation Display Reaction of
measurement
Alarming relay Cause Remedy
01 XX Hardware error Err Halt Error relay Fault in a hardware compo-
nent or the board Replace evaluation unit
04 01 Watchdog reset !! RUN Dependent on
code 44
High electrical interference
or faulty hardware Check power line for possible interfer-
ence
If necessary, replace evaluation unit
02 Watchdog reset
>2x in 10s Err Halt Error relay As above, but the malfunc-
tion occurred several times
within 10s. Check power line for possible interfer-
ence
If necessary, replace evaluation unit
05 01 No count rate Err Halt Error relay No counting pulse occurred
within 10s (FSK) or 120s
(GMZ) Replace probe
06 01 HV < -20% Err Halt Error relay HV is 20% below the HV
start value of code 54 Check HV and standard HV.
If necessary, update standard HV.
If necessary, replace detector.
02 HV > +40% Err Halt Error relay HV is 40% above the HV
start value of code 54 Check HV and standard HV.
If necessary, update standard HV.
If necessary, replace detector.
03 HV < 500V Err Halt Error relay HV is at lower limit at 500V Check HV.
If necessary, replace detector.
04 HV > 1300V Err Halt Error relay HV is at upper limit at 1300V Check HV.
If necessary, replace detector.
09 01 Detector tempera-
ture exceeded
(only FSK) !! RUN Dependent on
code 45
Detector heating up > value
in code 46
(only FSK) Reduce ambient temperature on probe:
e.g. through heat deflection plate or
water cooling.
10 01 EVA temperature
exceeded !! RUN Dependent on
code 47
EVU heating up > value in
code 48 Reduce ambient temperature on evalu-
ation unit
11 01 Communication
error Err Halt Error relay Faulty communication de-
tected (only FSK) Replace probe or evaluation unit or
eliminate line interruption
17 01 Date error !! RUN Dependent on
code 44
Date error detected Check date in code 01/02, if necessary
update it
22 01 Interference radia-
tion detection !! Waiting time
code 41
Dependent on
code 42
Interference radiation or
faulty calibration. Corre-
sponds to error messages
35.04 to 35.08, will be
checked during operation. See code 40 on page 38.