USER MANUAL 1.10 | DC1000 DIALOG-CONTROLLER
Berghof Automation GmbH | Harretstrasse 1 | 72800 Eningen | www.berghof.com
DC1000_HB_en_2D0982010ZD00.docx | 2VF100108FE04.docx
62
Check and adjust the network mask.
Net mask:
The
“+/-”
keys can be used to adjust and set each indivi-
dual network mask byte. The
“Save Mask”
button is then
used to save the settings. New settings will only take effect
after a restart! The
“EXIT”
button allows you to leave the
menu without saving any changes which may have been
made.
Check and adjust the gateway IP address.
Gateway IP:
The
“+/-”
keys can be used to adjust and set each indivi-
dual gateway IP address byte. The
“Save G-IP”
button is
then used to save the settings. New settings will only take
effect after a restart! The
“EXIT”
button allows you to
leave the menu without saving any changes which may
have been made.
Check and adjust the communications parameters.
Link Mode:
Auto:
Automatic parameter setting negotiated among the
communications parameters (default setting). The default
settings should only be changed under special circumstan-
ces (e.g. communications problems).
100base-Tx-FD: 100 MBit/s, full duplex
100base-Tx-HD: 100 MBit/s, half duplex
10base-T-FD:
10 MBit/s, full duplex
10base-T-HD:
10 MBit/s, half duplex
The
“Save”
button is used to save the new setting. New
settings will only take effect after a restart! The
“EXIT”
button allows you to leave the menu without saving any
changes which may have been made.
Ethernet
“Net mask”
Ethernet
“Gateway IP”
Ethernet
“LINK PARAM”
