92
Universal Wireless Device System
VectorBRIDGE
AMC10: Door/ Window Contact
n
n
Remove Cover
At the notched location on the cover, insert the
flat blade of a small screwdriver between the base
and the cover and twist the screwdriver to pop
the cover off.
n
n
Install Battery
Use care when installing the battery and ob-
serve the correct polarity (see Figure 1). Use only
the Lithium EL123AP battery.
Reed Switch
Tamper Switch
External Contact Terminals
Fig. 1 -
Install Battery
+
+
Battery MAY EXPLODE if mistreated. Do not
recharge, disassemble or dispose of in
fire.
n
n
Locate Transmitter
Select the location
where the transmitter is to
be mounted. Perform the
Module
Placement Test
to ensure that the selected
location is in range of
the wireless receiver
(see receiver Installation
Manual for instructions).
n
n
Remove Circuit
Board
Before mounting the unit, remove the circuit
board. At the notched location on the base which
is on the same side as the reed switch, insert the
blade of a small screwdriver between the base
wall and the bottom of the circuit board and pry
the circuit board up.
+
+
Do not touch the coils on the circuit board
as this may damage the unit.
n
n
Mount Transmitter and Magnet
Mount the backplate of the transmitter using the
screws provided and replace the circuit board.
The head of the screw
must be below the circuit
board so that the sensor is
not shorted out. Use flat-
headed screws only.
Mount the magnet no
more than 6,4 mm from the
transmitter. Use the
spacers provided. Once the
unit and magnet are
mounted, open and close
the window/door to en-
sure that none of the parts
interfere with this move-
ment.
+
+
Only one magnet can be used per trans-
mitter.
n
n
Using External Contacts
The external contact terminals can be used to
connect external contacts or other switches/de-
vices to the universal transmitter. Install the addi-
tional device as per the manufacturer's instruc-
tion.
+
+
The input is normally closed and is not
supervised.
The wires connecting the external device to the
input terminals must not exceed 1 m in length. The
contact and transmitter must also be in the same
room. The wires connecting the external device to
the input terminals can be any length provided that
the resistance of the wire does not exceed
100 Ohms.
+
+
Only one contact can be used. If an exter-
nal contact is used, do not install the mag-
net.
n
n
Tamper Switch
There is one tamper switch on the AMC10 board.
Removing the cover will cause a zone tamper.
n
n
Enrolling a AMC10
On the back of the door contact housing, there
will be two serial numbers, a five digit and six digit.
Please refer to your receiver Installation Manual
for information on which serial number should be
enrolled.
Fig. 2 -
Locate
Transmitter
Fig. 2 -
Mount
Transmitter and
Magnet
Cap
Magnet
Spacer
Spacer
(if required)
Summary of Contents for VectorBRIDGE
Page 95: ......