Bentel Security VectorBRIDGE, Installation Manual, Page: 62 / 96

62
Universal Wireless Device System VectorBRIDGE
Enrolling Wireless Devices
This section describes how to enroll Wireless Devices (AMD10A, AMD10,
AMC10 and ASD10) and Wireless keys (ARC10). For further information on
these devices refer to the
Instructions inserts inside the device packages.
n n
Electronic Serial Numbers
Each Wireless device has a 6 digit Electronic Serial Number (printed on the
back of the device). The 6 digits reduce the possibility of duplicate ESNs. The
ESNs must be used when enrolling Wireless devices.
The serial numbers may include hexadecimal digits (A, B, C, D, E and F). Refer
to the following table for the corresponding keys.
Press the number key for at
least 3 seconds ...
1 1 2 2 3 3 4 4 5 5 6 6
... to enter the haxadecimal
digit ...
A B C D E F
+
The AMD10A, AMD10, ASD10 and ARC10 Wireless Devices have 5 digit and 6
digit serial numbers (printed on the back).
Only the 6 digit serial numbers can
be used when enrolling Wireless Devices with this system.
n n
Enroll Sensors
1 Press the PROG ( 1 ) button on the Interface for 5
seconds.
Select Select _ _ Option Option ___ ___
Enroll Enroll _ _ Sensors Sensors __ __
2 Press either
9 9
or
0 0
to scroll for the Enroll Sensors
option, then press
E E
to continue or press
e e
to exit
programming.
Select Select _ _ Option Option ___ ___
Enroll Enroll _ _ Sensors Sensors __ __
3 Press either
9 9
or
0 0
to scroll for the Zone the Sensor
is to occupy, then press
E E
to continue or press
e e
to go back to step 2.
Select Select _ _ zone zone _____ _____
Zone Zone _ _ Ø1 Ø1 _________ _________
4 Enter the ESN of the Sensor. Wrong digits can be
corrected by using
A A
or
B B
to scroll the ESN, and
by entering the correct digit.
ESN ESN _ _ Zone Zone _ _ Ø1 Ø1 _____ _____
ØØØØØØ ØØØØØØ __________ __________
5 Press
E E
to enroll the ESN shown on the display or
press
e e
to go back to step 3.
ESN ESN _ _ Zone Zone _ _ Ø1 Ø1 _____ _____
259ØØ4 259ØØ4 __________ __________
6 Record the serial number, and the assigned zone number in Table A5 in the
Programming Sheets.
7 Repeat steps 3 to 6 until all the Sensors have been enrolled, then press
e e
to
go back to step 2.
+
The sensors will not work properly until programming is completed (refer to the
“PROGRAMMING THE INTERFACE” section).