Bentel Security VectorBRIDGE, Installation Manual, Page: 68 / 96

68
Universal Wireless Device System VectorBRIDGE
n n
Inputs
Memory Reset and Scrolling
Input for viewing and deleting the Interface memory.
Ø
Terminal connected to ground for LESS than 3 seconds > Scroll memory.
Ø
Terminal connected to ground for MORE than 3 seconds > Reset memory.
This Input can be connected to a Control Panel Output that connects to Ground
for at least 3 seconds when the Control panel is armed. In this way, the Interface
Memory will be deleted automatically each time the Control Panel is armed.
+
The R/S Input operates in the same way as the R/S button ( 2 ).
Enable Memory
When this Input is connected to Ground the Interface will record the alarms
generated by Wireless Sensors.
+
Other Events such as: Tamper, Low Battery, Missing and Jamming will be re-
corded, regardless of the Enabled/Disabled status of the MEM Input.
Connect this Input to a Control panel Output that is connected to Ground during
armed status. In this way, the Interface will record alarms generated by Wire-
less Sensors only
when the Control panel is armed.
+
The MEM Input can also control the operating mode of Outputs KA, KD and KS,
in accordance with the status of the
Use MEM xTer. K option (refer to “Use
MEM for Terminal K” in the “PROGRAMMING THE INTERFACE” section).
n n
Outputs
+
It is possible to program the Standby status of the Outputs described in this
section (refer to “Standby for Outs” in the “PROGRAMMING THE INTERFACE”
section):
OUTPUT STANDBY OUTPUT STANDBY ACTIVE OUTPUT
Normally Closed
Terminal Closed to Ground Terminal Open (floating)
Normally Open Terminal Open (floating) Terminal Closed to Ground
Tamper
This Output will be activated by Tamper on Wireless Sensors, the Receiver or
on the Interface. Standby status will be restored when Tamper signalling stops.
Tamper on the Receiver is generated when the Snatch switch 20 is activated
(Receiver snatched from the wall), or when the Receiver Tamper switch 21 is
activated (Receiver box opened). Interface Tamper is generated when the Inter-
face Tamper switch
8 is activated (Interface box opened)).
+
The Interface Tamper switch 8 can be disabled by connecting jumper 7 .
Connect the TMP Output to the end of the Control panel Tamper line. If the Control
panel Tamper line is balanced, connect the Balanced Resistor to this Output.
R/S
MEM
TMP