Bennett CNG Spec. 100 Series, Operator'S Manual

Page: 7 / 58

Bennett CNG Spec. 100 Series Operators Manual Safety Information
1
SECTION 1: SAFETY INFORMATION
For safe installation of this equipment, read and understand all dangers, warnings, and cautionary information. Save this safety
information in a readily accessible location. Look for the following warnings throughout the manual:
Red and White “DANGER” means: If you do not follow the instructions, severe injury or death will occur.
Orange and Black “WARNING” means: If you do not follow the instructions, severe injury or death can occur.
Yellow and Black “CAUTION” means: If you do not follow the instructions, damage can occur to the dispenser.
Blue and White “ IMPORTANT” means: helpful tips and other recommendations on equipment installation, usage, and
maintenance should be observed.
DANGER PELIGRO DANGER

FIRE, EXPLOSION, INJURY, OR DEATH WILL OCCUR IF FUEL FILTERS ARE CHANGED BY UNTRAINED PERSONNEL. MAKE
SURE, ONLY TRAINED PERSONNEL CHANGE FILTERS.

TO PREVENT INJURY TO YOU FROM VEHICLES AND ONLOOKERS, ALWAYS PLACE A BARRIER AROUND THIS EQUIPMENT
BEFORE PERFORMING SERVICE OR MAINTENANCE.

CNG IS FLAMMABLE. NO SMOKING OR OPEN FLAME.

DISCONNECT ALL POWER, RELIEVE PRESSURE TO THIS EQUIPMENT, AND ASSOCIATED COMPRESSOR DURING
INSTALLATION, SERVICE, OR ANY MAINTENANCE I.E., CHANGING FILTERS.
WARNING ADVERTENCIA MISE EN GARDE

You must have training in the installation, service, or maintenance of this equipment (dispenser, pump, console, control box,
or submerged pump) before working on it. Maintenance repairs must be done by authorized personnel only. Warranty work
may only be performed by Bennett certified technicians.

There must be a message near the dispensers that says, “Natural Gas Vehicle Fuel Cylinders shall be periodically inspected
(normally every 3 years) to ensure safe operation of the vehicle or cylinder manufacture.”

To prevent electric shock, keep the electrical parts of the dispenser dry.

Electronic components are static sensitive. Use only proper static precautions (e.g. static straps) before working on the
equipment.

The shut-off ball vale for the incoming CNG Line must be closed when service or maintenance is performed on this
equipment.

Vehicle engine must be turned off while dispensing product.

No ignition source can be within 10-feet of the dispenser.

A portable fire extinguisher with a rating of no less than 20-B.C. must be provided in the dispensing area.

You must have training in the operation and programming of this dispenser before using it. READ THE OPERATORS MANUAL.

Make sure this equipment is correctly grounded. Failure to do will cause injury or damage equipment or improper operation.
Improper grounding voids the warranty.

When anchoring the dispenser, always level the dispenser with shims before bolting to the island. DO NOT shim the middle
of base rails to bolt down the dispenser.

If the breakaway is not provided then one must be installed that will disengage at 150lbs.
CAUTION PRECAUCIÓN MISE EN GARDE

Do not drill holes in fuel dispensers. Holes can cause failure of the electronic equipment. THE WARRANTY WILL BECOME
VOID. Use only adhesive backed sign mounting brackets.
IMPORTANT IMPORTANTE IMPORTANT

All trained technicians must work in accordance to all requirements, standards, and guidelines specified by the suppliers
Environmental Standards® Health, Safety, Security & Environment (HSSE) policies.
Note: Bennett Pump highly recommends
all technicians observe HSSE policies defined by the supplier. Bennett Pump does not impose any restrictions or additional
requirements contained in Environmental Standards® Health, Safety, Security & Environment (HSSE) policies.
!! READ AND UNDERSTAND ALL WARNING LABELS ATTACHED TO THE DISPENSER !!