Benelli 302R 2017, Owner'S Manual

Page: 111 / 454

3 - 4
Instrument and control functions
EN
3
Turn signal indicator lights “ ” and
“ ”
Each indicator light will flash when its cor-
responding turn signal lights are flashing.
Neutral indicator light “N”
This indicator light comes on when the
transmission is in the neutral position.
High beam indicator light “ ”
This indicator light comes on when the
high beam of the headlight is switched
on.
Oil pressure warning light “ “
This light switches on when the engine oil
pressure is low.
It is possible to check the electrical circuit
for the light by turning the key to “ ”.
Once the engine is running, the light
should switch off.
If the light does not switch on when the
key is turned to “ ” or if the light stays on,
get the electrical circuit checked by an au-
thorised Benelli centre.
TIP
Even if the oil level is sufficient, the war-
ning light may flicker when riding on a
slope or during sudden acceleration or
deceleration, but this is not a malfunction.
Engine trouble warning light “ ”
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
system.
The electrical circuit of the warning light
can be checked by turning the key to “ ”.
The warning light should come on for a
few seconds, and then go off.
If the warning light does not come on ini-
tially when the key is turned to “ ”, or if
the warning light remains on, have a Be-
nelli dealer check the vehicle.
Tachometer
The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Coolant temperature
This shows the temperature of the coo-
lant.
The coolant temperature varies with chan-
ges in the weather and engine load. if the
“warning lamp” flashes, stop the vehicle
then stop the engine and let it cool.
WARNING
Do not continue to operate the engine
if it is overheating.
Digital clock
Shows the time in hours and minutes.
Digital clock setting
Push and hold the menu switch “SELECT”
for 3 seconds to enter the setting mode
“TOTAL KM”
Press and hold down the ”SELECT“ button
for 3 seconds until the reading begins to
lash.
Adjust the hour by pressing the“RESET”
button.
Press the ”SELECT“ button to pass on to
adjust the minutes. Adjust the minutes by
pressing the ”RESET“ button.
Press the “SELECT” button again to quit.
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the “E” reserve area.
As soon as the inal line starts to lash, there
is an autonomy of about 1.3 litres of fuel.
Speedometer
Push and hold the menu switch “SELECT”
for 3 seconds to enter the setting mode
“TOTAL KM”
Speedometers Indicates the vehicle’s spe-
ed in km/h or mph. To pass from one to
the other, press the “RESET” button.