Benelli 302R 2017, Owner'S Manual

Page: 152 / 454

6 - 21
Periodic maintenance and adjustment
EN
6
• Use only the specified brake fluid;
otherwise, the rubber seals may
deteriorate, causing leakage.
• Refill with the same type of brake
fluid. Adding a brake fluid other
than DOT 4 may result in a harmful
chemical reaction.
• Be careful that water or dust does
not enter the brake fluid reservoir
when refilling. Water will signifi-
cantly lower the boiling point of
the fluid and may result in vapor
lock, and dirt may clog the ABS
hydraulic unit valves.
NOTICE
Brake fluid may damage painted surfa-
ces or plastic parts.
Always clean up spilled fluid immedia-
tely.
As the brake pads wear, it is normal for the
brake fluid level to gradually go down. A
low brake fluid level may indicate worn
brake pads and/or brake system leaka-
ge; therefore, be sure to check the brake
pads for wear and the brake system for
leakage. If the brake fluid level goes down
suddenly, have a Benelli dealer check the
cause before further riding.
Changing the brake fluid
Have a Benelli dealer change the brake
fluid at the intervals specified in the pe-
riodic maintenance and lubrication chart.
Drive chain slack
The drive chain slack should be checked
before each ride and adjusted if necessary.
To check the drive chain slack
1. After stopping the engine, place the
vehicle on a rear stand on a horizontal
surface and with the gear in neutral.
2. Measure the drive chain slack as shown.
3. After running the rear wheel forward
occur else where in the free play chain: it
must be constan.
4. If the drive chain slack is incorrect,
Drive chain slack:
10 - 15 mm (0.40 - 0.60 in)