1523.5-0000010 OM
22
The layout of positions of the starter and instruments disconnect switch is given in figure
2.2.2 and on the informational plate of the switch.
Figure 2.2.2 – Layout of positions of the starter and instruments disconnect switch
ATTENTION: THE REPEATED STARTER ENGAGEMENT IS POSSIBLE ONLY AFTER
RETURN OF THE KEY INTO THE POSITION “0” OF THE SWITCH. TO TURN THE
STARTER AND INSTRUMENTS SWITCH INTO THE POSITION “III” IT IS NECESSARY
TO PRESS IN THE KEY WHEN IN “0” POSITION AND TURN IT CONTRACLOCKWISE!
The multifunctional under-wheel switch 2 on the left (fig 2.2.1) provides activation of turn
blinkers, switching between upper and lower beam of headlights, upper beam signalling
(blinking), audible beep.
Turn blinkers are activated when shifting under-wheel switch 2 lever from the intermediate
position forward (“a” – right turn) or backwards (“
б
” – left turn) according to figure 2.2.3.
After tractor turning, the lever automatically returns to the initial position.
To switch on road headlights, set central light switch 5 (fig. 2.2.1) into the position “III” as it
is shown below, and set the under-wheel switch lever into the intermediate position “
в
” –
“lower beam” according to figure 2.2.3. For switching on “upper beam”, push the switch
lever against the stop (position “
г
”). The positions of a lever “lower/upper beam” shall be
fixed.
When pulling the lever against the stop (position “
д
”, fig.2.2.3) from the position “lower
beam”, non-fixed engagement of upper beam is carried out, upper beam blinking, irrespec-
tive of the central light switch position.
The audible beep is activated when pressing the lever in axial direction (the switch lever
axle). The beep can be activated in any position of the switch lever.
Figure 2.2.3 – The operation scheme of the multifunctional under-wheel switch on the left
Multifunctional under-wheel switch on the right 3 (figure 2.2.1) provides
the engagement of
two-speed windscreen wiper and washer.
