1523.5-0000010 OM
110
4.4.2 Drawbar hitch DH-2V (short towing yoke)
Figure 4.4.1 – Installation variant diagram of DH-2V (short towing yoke)
Table 4.3 – Basic parameters and coupling dimensions of DH-2V (short towing yoke)
Standard size (configuration) of the device
DH-2V (short towing yoke)
1 Variant
Yoke acc. to ISO Yoke acc. to GOST
2 Mounting location
Rear lifting device
3 Design features
Non-rotational, height adjustable
4 Assignment
For connection and coupling of trailed,
semi-trailed implements with traveling
wheels, including tractor semi-trailer
type
5 DH yoke dimensions, mm:
а
) connecting pin diameter
b) yoke gap height
c) yoke gap depth
40
85
70
d) yoke position
1
for the implements driven by
rear PTO shaft
Extreme lower position
e) distance between the PTO butt end and the
connecting pin axis, mm
110
160
6 Trailing device for coupling to DH:
а
) type
Rigid, with tractor drawbar clevis
b) vertical load in hitch point, kN, not more than 25
c) turning angle of the implement trailing device
in horizontal plane, degrees, not less than
±60
d) protective device type
Safety chain (rope)
2)
e) connection point of the protective device on the
tractor
Lifting device holes
________________________________________________________________________
_________________________
1)
Recommended.
2)
Implement
accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-2V YOKE TO A POSITION WHERE
ITS BODY OVERHANGS THE DH SUPPORTING BRACKET END (UP OR DOWN) FOR
MORE THAN 15
ММ
!
