1.3.8 Electrostatic discharge
Avoid electrostatic discharge! There are electronic components integrated into the devices
which might be destroyed by electrostatic discharge. Observe the safety precautions against
electrostatic discharge according to DIN EN 61340-5-1/-3. Ensure that the environment
(persons, workplace and packing) is well grounded when handling these devices
1.3.9 General hazard warning - residual risk
All components are designed according to valid regulations of the construction of technical
systems in regards to operational safety and accident prevention. Independently from this
the use can lead to hazards for the user or third parties as well as for other technical facilities.
Therefore the device may only fulfill its intended use in a
and
technically acceptable
faultless condition. This has to happen in adherence of the according safety regulations and
under observance of the operating manual.
the device and its attachment parts
Inspect
regularly
damage
leakages. Liquids
and check them for possible
or
could escape under
high pressure
leaky
from pressurized components which become
.
1.4
Use of hydraulic hoses
If hydraulic hose lines are installed at the pump, the operator has to observe / ensure the
following:
·
Examination of proper assembly and function are to be carried out according to regionally applicable directives.
·
Examination of pipes and hoses regarding safe provision, use, proper assembly and function has to be carried
out according to regionally applicable directives.
·
Inspection intervals may not be exceeded
·
Defective pipes or hoses must be replaced immediately and professionally
·
Hydraulic hoses and polyamide pipes are subject to a natural aging-process and thus have to be exchanged in
regular intervals according to the manufacturer's specifications
1.5
Transport and storage
Use a suitable lifting device for the transport.
Do not
the central lubrication system or
.
throw
impose it to shocks
Use a suitable lifting central lubrication system for transport.
Store the system at a temperature between -40°C to +70°C.
Observe all valid safety and accident prevention regulations for the transport. Wear
suitable
predective
adequate distance to suspended loads
equipment if necessary. Keep
. The
transport help or the elevating device must have the
adequate carrying capacity.
When storing the device pay attention that the storage area is cool and dry in order to avoid corrosion of the
individual parts of the device.
1.6
Shutdown
Relief the central lubrication pump from pressure! Shut down current!
Separation of central lubrication pump from current supply must be done by a professional electrican.
Remove all pipes and hoses from the device and loosen all fastenings for the demounting.
1.7
Disposal
Observe the disposal instructions of the lubricant manufacturer when lubricant is changed!
Lubricants or cloths contaminated with lubricant or similar must be collected in specially
marked receptacles and disposed accordingly Disposal of the central lubrication system
.
must be done properly and professionally and according to the national and international
laws and regulations.
Moreover, BEKA central lubrication systems could contain batteries. Professionally and
properly disposed batteries will be recycled. They contain important raw materials.
Note!
9
Subject to alterations!
...a product from
BAL2076_central lubrication pump_01
19EN
© BEKA
2019 All rights reserved