1.3
Safety instructions
All persons that are in charge with the assembly, start-up, maintenance and operation of the device must
carefully read these instructions. Furthermore this manual must permanently be available at the site of operation!
Basic notes for setup, operation and maintenance can be found below.
1.3.1 Safety notes
Do not only observe the safety instructions within this main point but also have a look at the special safety
warnings that are implemented in other parts of this documentation.
Warning of electrical voltage.
Safety instructions which in case of non-observance might cause hazards to persons are
marked with the general danger symbol.
This symbol warns of hot surfaces
Warning of suspended loads.
Warning of material damage due to electrostatic discharge! Marks potential risks which may
result in material damage, if not avoided.
This heading is used if the improper or general non-observance of the operating manual,
specified work flow and the like might result in central lubrication system damage.
This term is used to point out particular details
Notes directly attached at the unit, must strictly be followed and held in readable condition!
1.3.2
staff
Qualification and training of
The staff in charge for operation, maintenance, inspection and assembly has to have the
according qualification for these tasks. Competence, responsibility and supervision of staff
must be clearly defined by the operator. In case the staff does not have the necessary
knowledge it has to be instructed and trained accordingly. The operator is obliged to ensure
that the staff fully understands the contents of this user information.
1.3.3 Hazards in case of non-observance of the safety instructions
Results of non-observance of the safety instructions can be hazards to persons, the
environment and for the
Non-observance of the safety
central lubrication system.
instructions may result in the loss of any liability claims. In detail the non-observance could
entail the following hazards:
·
F
system
ailure of important
functions.
·
Failure of prescribed methods for maintenance and repair
·
Danger to persons by electrical, mechanical and chemical effects
·
Danger to the environment by leakage of hazardous substances
Attention!
Note!
7
Subject to alterations!
...a product from
BAL2076_central lubrication pump_01
19EN
© BEKA
2019 All rights reserved