Baxi ECOGEN 24/1.0, Installation & Servicing Instructions Manual

Page: 47 / 94

page 46
10.12 THINK Controller, 5 LED Receiver and Wall Cradle Accessory ( Figs. 42 & 43 )
Display Descriptions
Burner in Operation 1 ­ Engine 2 ­ Supplementary
Heating to the Comfort Set Point
Heating to the Reduced Set Point
Central Heating Times Active
DHW Times Active
Combustion Check Function Active
Holiday Function Active
Manual Override ­ Time Switch Function Overridden
Time Switch Function Active
Wireless Communication Established
THINK Controller Configured as a Room Sensor
Error Message
Stand By ­ Appliance On/Off
Outdoor Sensor Connected
System / Appliance Attention Required
Maintenance / Special Mode
Change Battery (only if radio control fitted)
1. The THINK Controller is effectively an interface which allows the householder to programme the appliance to provide the desired comfort levels for the central heating and
hot water. It also gives information on the appliance ­ error codes electrical power generated etc.
2. Whilst the THINK Controller is on the appliance the standard screen displays the appliance flow temperature. External sensors/room thermostats can be connected to
monitor and control the room and domestic hot water temperatures ­ see sections 10.3 to 10.11 .
3. The THINK Controller may be removed from the appliance and configured as a programmable room sensor ­ in which case the standard screen displays the room
temperature.
4. If the THINK Controller is to be used as a room sensor it must be configured so that the appliance will recognise it as such.
Display showing all available segments