Baxi ECOGEN 24/1.0, Installation & Servicing Instructions Manual

Page: 13 / 94

* A THINK Controller here implies that the RF facility is not being used ­ the customer has reverted to an all wired system
All RF connections or mixed with the user reset off appliance
NOTE:­ Either a 5 LED Receiver or a THINK Controller must be fitted to the appliance for the safety of the user or visiting service personnel.
page 15
7.0 Site Requirements
7.1 Location
1. Must not be located in a living space (recommend locations, garage, utility, and outhouse).
2. There must be sufficient space at the installation location and in the route to the location for maneuvering and operating the lifting equipment (Genie GL­8 lifting equipment
dimensions are 64cm wide x 175cm high x 95cm deep). This space must be maintained for future access of the lifting equipment for maintenance.
3. Wall structure must be a solid flat load bearing wall of brick or block. Partition and timber frame walls, and dot and dab plaster board are not suitable. If in doubt consult a
Structural Engineer.
4. To eliminate the transmission of noise from the appliance and its pipework it is recommended that the central heating pipework is adequately routed and clipped so that
contact between the structure of the building and pipework is eliminated.
Fig. 9
Ensure that there is adequate clearance for the lifting equipment. (Genie GL­8 lifting equipment dimensions are 64cm wide x 175cm high x 95cm deep).