Barco PULSAR BG, User Manual

Page: 98 / 126

Separate IF Outputs P
ULSAR
BG
Page 2
3 INSTALLATION
Please read this chapter carefully before installing the option.
The installation procedure is only necessary when ordering this option sepa-
rately. When ordering a P
ULSAR
with Separate IF Outputs, the installation has
already been carried out during production.
For location of the boards, connectors and jumpers use the different layouts in chapter 4 : layouts.
Before changing anything in the P
ULSAR
, remove the power cord to switch off
the power supply.
3.1 Opening The P
ULSAR
Before changing or removing anything in the P
ULSAR
, remove the power
to switch of the power supply.
•
Unplug the power cord to turn off the P
ULSAR
.
•
Unscrew the nine screws (Torx 10) holding the top cover.
•
Pull the top cover backwards and remove it.
•
Loosen the nine screws (Torx 10) holding the bottom cover.
•
Remove the bottom cover.
3.2 Installing The Separate IF Outputs Board
Installing this option has as a consequence that the option 4.5 MHz Aural
Subcarrier or the Nicam Intercarrier is only possible in a single sound carrier
version or in a dual sound carrier version delivered as a mono device.
The option Composite IF Aux input is not possible any more.
For the right location of the boards, connectors and screws see the internal layout diagram.
•
Install the Separate IF output board.
•
Fix the board with the 4 screws on the chassis profiles.
•
Install the power supply interconnection board.
•
Fix the board with the screws on the chassis profiles.
•
Bridges to be set on the mainboard.
Bridge Function Position
BR5
Enables / disables separate IF outputs Remove
BR6
Enables / disables separate IF outputs Remove
WARNING
REMARK
REMARK
REMARK