Barco F80-Q12, User Manual

Page: 130 / 210

R5906852 /09 F80 130
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet
network can serve as the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple
universes are possible.
For a full list of all DMX channels, values and possible actions, see “DMX chart”, page 205 .
About the DMX menu
DMX Feature What can be done?
DMX Mode Two different modes for DMX are available.
•
Basic : A basic configuration where 2 channels are implemented.
• Extended : A full configuration, spread over 14 channels.
For the full mapping of each used channel, refer to the DMX chart in the appendices. See
“DMX chart”, page 205 .
Start Channel Before a projector can execute DMX commands, a unique address (named DMX address
or Starting channel) should be given to the projector.
This address can vary from 1 to 512.
DMX Monitor If a DMX device is connected, the settings per channel can be displayed via the Monitor
button.
Reset for
Max intensity You can change the Shutter and intensity via DMX Channel 1 (both in Basic and Extended
mode).
If no DMX signals are available, you can reset the intensity value to its default (maximum)
value of 255 using the
Max Intensity button.
Auto power
down The projector can be forced to shut down after a certain time-out period if no DMX signals
are available.
Note : Value is set in minutes.
DMX Art-Net DMX can be sent via the Ethernet connector to the projector instead of the classic DMX
connector. This function can be enabled or disabled. Art-Net is generally used when more
than 512 addresses are used in your setup.
DMX Art-Net
Universe Note: DMX Art-Net Universe can only be used when Art-Net DMX is enabled.
If Art-Net is enabled, you can specify which DMX universe this projector belongs to.
Front XLR
connector If available on your projector, the power of the XLR connector on the front side of the
projector can be enabled and set to a desired value.
Note : If no front XLR connector is available on your projector, this option remains hidden.
How to set up DMX?
1. In the main menu, select System Settings → Communication → DMX .
Image 10–19 Communication menu, DMX
The DMX menu is displayed.
GUI – System Settings