Barco DICOM THEATER, System Manual

Page: 81 / 82

System manual DICOM Theater 82
The properties are:
Product Type Number: .... The identification of the projector type
Product Serial Number: ... The projector serial number
Product Ordering Code: .. The projector order number
Software version: ............ The version of internal software
Portrait/Landscape: ......... The projector’s current orientation
Front/Rear-Ceiling/Table: The projector’s current configuration
Projector Address: ........... The projector’s internal RS-232 address
Lamp Runtime: ................ The number of hours the projector lamp has
been operating
Projector Runtime: .......... The number of hours the projector has been
operating
Input Source: ................... The currently selected input source
Video File: ....................... The current input format
Horizontal Timing: ........... The selected signal’s horizontal frequency
Vertical Timing: ................ The selected signal’s vertical frequency
Resolution: ...................... The selected signal’s resolution (H x V)
Troubleshooting the stabilization process
The projector stabilization has stopped unexpectedly
Possible causes:
• No communication with projector. The projector may be switched
off, removed, or the RS-232 cable may be disconnected at the
projector’s or PC’s side.
• No communication with optical sensor. The sensor connection to
the PC may be disconnected.
• The optical sensor is not or no longer positioned on the sensor
patch.
• The user has selected another signal input or another preset for the
projector.
In all of these cases, you must restore any problems in the
connections (if appropriate). Then you must run MediCal Pro and
select the proper Preset. This should restart the stabilization.