System manual DICOM Theater
38
Installing the BarcoMed 2MP1HP Windows XP
Software
SPECIAL NOTE: Prior to installing the BarcoMed driver you MUST
install the BarcoMed Display Controller(s), connect the high resolution
display(s) to the controller(s), and turn the high resolution display(s)
on. Refer to the Hardware Installation section of this manual for
instructions on installing the BarcoMed Display Controller(s) and
connecting them to the high resolution display(s).
The following software installation instructions presume that Windows
XP is already installed on your system. If you need to install or reinstall
Windows XP on your system you must first remove the BarcoMed
Display Controller(s) and use a 3
rd
party VGA controller and VGA
monitor during the Windows XP installation process.
Using the BarcoMed Product Installation Wizard
To install your BarcoMed 2MP1HP Windows Display Controller Driver
and BARCO DPMS Screen Saver for the first time follow the steps
below. If you are reinstalling the driver or installing a new driver release
over an existing driver release skip to step 6 below:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the Hardware Installation Guide that came with your
BarcoMed Display Controller(s) for more information.
2. Boot the machine and log in using an account with administrative
privileges.
3. Windows XP will do a thorough inspection of your system and will
announce that it has found new hardware. Please be patient as this
may take up to 5 minutes.
4. For each BarcoMed 2MP1HP Display Controller you have installed,
Windows XP will automatically launch the “Found New Hardware
Wizard” (see figure 14 on the next page). Click “Cancel” to exit the
Wizard. Continue to click “Cancel” until Windows XP stops
launching the “Found New Hardware Wizard - Video Controller”.
5. Windows XP may also tell you that it has finished installing new
devices and may ask you if you want to restart your computer. If it
does, click “No”.
6. Insert your BarcoMed Software CD into your computer’s CD drive.
The “BarcoMed Product Installation Wizard” should start
automatically. If it doesn’t start within 5 minutes, browse the
contents of your BarcoMed Software CD and double click on the
file: “Setup.exe” to start the wizard.
Summary of Contents for DICOM THEATER
