Barco DICOM THEATER, System Manual

Page: 28 / 82

System manual DICOM Theater 29
Installing the BarcoMed 2MP1HP Windows 2000
Software
SPECIAL NOTE: Prior to installing the BarcoMed driver and related
software you MUST install the BarcoMed Display Controller(s),
connect the high resolution display(s) to the card(s), and turn the high
resolution display(s) on. Refer to the Hardware Installation section of
this manual for instructions on installing the BarcoMed Display
Controller(s) and connecting them to the high resolution display(s).
The following software installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
rd
party VGA card and VGA
monitor during the Windows 2000 installation process.
Using the BarcoMed Product Installation Wizard
To install your BarcoMed 2MP1HP Windows 2000 Display Controller
Driver and BARCO DPMS Screen Saver for the first time follow the
steps below. If you are reinstalling the driver or installing a new driver
release over an existing driver release skip to the step 5:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the Hardware Installation Guide that came with your
BarcoMed Display Controller(s) for more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each BarcoMed 2MP1HP Display Controller you have installed,
Windows 2000 will automatically launch the “Found New Hardware
Wizard”. Click “Cancel”. Continue to click “Cancel” until Windows
2000 stops launching the “Found New Hardware Wizard - Video
Controller”.
4. Windows 2000 may advise you that it has finished installing all the
new devices in your system and that you must reboot your system
in order for the changes to take effect. If it does, Click “No”.
5. Insert your BarcoMed Software CD into your computer’s CD drive.
The “BarcoMed Product Installation Wizard” should start
automatically. If it doesn’t start within 3 minutes, browse the
contents of your BarcoMed Software CD and double click on the
file: “Setup.exe” to start the wizard.
The BarcoMed Product Installation Wizard will start by inspecting
your system to make certain that all of the Windows components it
needs are up to date. If it determines that the Microsoft Installer is
current, the BarcoMed Product Installation Wizard will start by
displaying the BarcoMed Product Installation Wizard’s welcome