Barco DICOM THEATER, System Manual

Page: 71 / 82

System manual DICOM Theater 72
INSTALLING MEDICAL PRO AND
DICOM THEATER SOFTWARE
Install MediCal Pro on the PC. Follow the instructions from the
MediCal Pro User Guide.
Important: Do not forget you have to have Administrator privileges to
install or uninstall MediCal.
During installation, you will have to indicate you are using projectors in
your application. In that case, the Dicom Theater sofware will be
installed as well.
USING MEDICAL PRO
After installation of the hardware and software, you must start MediCal
Pro. With MediCal Pro, you can calibrate the display and projector, and
start the projector stabilization.
Proceed as follows:
1 Start MediCal Pro. If appropriate, you can connect to MediCal
Administrator.
2 During startup, MediCal Pro will detect the connected review
display(s). They will be added automatically to the system
configuration in MediCal Pro.
Note: In case the review displays were not automatically added to the
configuration, you can add them manually, by running the
Configuration Setup Wizard.
3 Add the projector(s) to the configuration by using the
Configuration Setup wizard.
4 For each projector added to the configuration, MediCal Pro displays
a dialog with which you can adjust the position and size of the patch
for the optical sensor.
5 If you have not done this yet, install and connect the optical sensor,
as described in the next paragraph. Or, you can position the patch
over the already installed sensor.
6 After closing the sensor patch dialog (by clicking OK), MediCal Pro
will check if a sensor is connected and installed properly.
7 For all the devices in the configuration, check if the DPMS setting is
turned on. Therefore, right-click on the display icon and select
Properties... from the drop-down menu. Then click on Details...
Check if the Powersave option is checked. If not, check it. This is
necessary to use the DPMS possibilities of the imaging board.