Balluff BDG F-NH Series, Configuration Manual

Page: 73 / 130

1 Introduction
1.1 Encoder types
This manual is assigned to all BDG Fxxxx-xxxx-
NH/NV…
The Balluff CANopen vendor id is: 0100 00E8h
The Balluff product code is: 100h
The revision number and the serial number vary for each individual encoder and can be found on the encoder’s
label.
1.2 About this manual
This technical manual describes the configuration and mounting possibilities for absolute-value encoders with a
CANopen interface produced by Balluff.
Ensure that you read the manual before commissioning
— check beforehand that you have the latest version of
the manual.
When reading, pay particular attention to the information, important notices and warnings that are marked with the
corresponding symbols (see 1.2.1).
Section Fehler! Verweisquelle konnte nicht gefunden werden. Quick start shows a way how to configure the
encoder in a very general setting with minimal functionality. For optimal usage of the device, it is necessary to
read all the following information. Abbreviations and specific wording is explained at the beginning of this manual.
This manual is intended for persons with technical knowledge in the handling of sensors, CANopen interfaces and
automation elements. If you do not have any experience in this field, request the assistance of experienced
personnel before proceeding.
Keep the information provided with our product in a safe place so that you can refer to it at a later date as
necessary.
1.2.1 Symbols
•
The INFO symbol indicates a section that contains particularly important
information for advanced use of the device.
•
The IMPORTANT symbol is shown next to a section of text that describes a
method for solving a particular problem.
•
The WARNING symbol indicates that the adjacent instructions must be observed
to ensure correct use of the device and to protect the user against hazards.