INTRODUCTION
WBPEEUI110501A0
E - 1
APPENDIX E - XM/SM/XE MAGNETIC FLOWMETER
INTRODUCTION
This appendix covers the configuration and calibration functions of the XM/
SM/XE Magnetic Flowmeter (Mag Flow).
XM/SM/XE MAGFLOW CONFIGURATION FUNCTIONS
Procedures explain the following functions:
•
Create/modify configurations.
•
Calibration.
The following functions apply to all devices and are similar or identical for
all devices. The procedures are not duplicated for each device type, they are
covered once for the PTS transmitter. Refer to
for the detailed
description of these functions.
•
Send configurations.
•
Erase configurations.
•
View configurations.
•
Get configurations.
•
Change working configurations.
For operation function procedures, (i.e.,
, ,
and
) refer to
.
To change calibration or configuration parameters of a smart field device
that is connected to an IMFBS01 module, the device must be taken off-line.
This is done at the INFI 90 OPEN console.
Interfacing the XM/SM/XE Mag Flow Meter requires a Type STC4 Smart
Terminal Cartridge. The cartridge inserts into the bottom of the STT03E ter-
minal. For an installation procedure of the STC cartridge, refer to
in Section 3. To order cartridges, refer to
Refer to Figure
for an overview of the configuration function.
CREATE/MODIFY CONFIGURATION
The
NEW
function allows you to input and save a complete configuration.
The
MODIFY
function allows you to change an existing configuration.
NOTE:
For illustrative purposes these procedures have been combined.
Any deviation between them will be noted in the
Comments
column.
STATUS
OUTPUT
SPECIAL FEATURE
F1
