Baby Lock Urity BLTY, Instruction And Reference Manual

Page: 323 / 332

ERROR MESSAGES
Main
te
nan
ce
a
nd
Tr
oubl
es
hoo
ting
Appendix A-19
A
1
OK to delete the selected pattern? This message is displayed when, after selecting a pattern,
or is pressed and the pattern is about to be
deleted.
OK to delete the setting?
This message appears when or is pressed to
delete the settings for a utility stitch. To delete the selected
settings, press .
OK to recall and resume previous memory? This message appears if the machine is turned off while
sewing, then turned on again.
Press to return the machine to the condition (pattern
position and number of stitches) when it was turned off. Follow
the procedure described in “If the Thread Breaks During
Sewing” on page E-27 to align the needle position and sew the
remainder of the pattern.
OK to reset the pattern’s border setting, position and/or angle? This message appears when you try to use the automatic
positioning function using the sensor pen with the border
pattern. (see page B-85)
OK to revert to the original position and/or angle? This message appears when you try to use the automatic
positioning function using the sensor pen with the pattern,
rotated or replaced. (see page B-85)
Preventive maintenance is recommended. This message is displayed when the machine needs to be
maintained. (see page A-3)
Raise the buttonhole lever. This message is displayed when the buttonhole lever is down,
a stitch other than a buttonhole is selected, and the “Start/
Stop” button or the “Reverse Stitch” button is pushed.
Remove Dual Feed module from the machine. This message appears when you try to start embroidering with
the dual feed foot attached to the machine. Remove the dual
feed foot before entering the embroidery mode. (see page
B-69)
Remove Embroidery foot with LED pointer from the machine. This message appears when you try to start sewing
utility/decorative stitch or character pattern with the
embroidery foot with the LED pointer attached to the machine.
Remove the embroidery foot with the LED pointer before
entering the sewing mode. (see page B-62)
Retrieving the pattern. Wait a moment. This message is displayed when the machine is retrieving a
previously saved pattern while in “Embroidery Edit” mode.
Sensor module error. This message appears when something is wrong with the
sensor unit of the machine. Consult your authorized retailer.
Set the clock. This message appears when the time/date is not set. Set
time/date. (see page B-22)
The bobbin thread is almost empty. This message is displayed when the bobbin thread is running
out.
The bobbin winder safety device has activated. Is the thread
tangled? This message is displayed when the bobbin is being wound,
and the motor locks because the thread is tangled, etc.
The carriage of the embroidery unit will move. Keep your
hands etc. away from the carriage. This message appears before embroidery unit moves.
The ending point cannot be selected for this stitch. This message appears when the function to specify the sewing
end point cannot be used with the current stitch. Select other
stitch. (see page B-83)
The needle position cannot be changed for this stitch. This message appears when the function to specify the needle
drop position cannot be used with the current stitch. Select
other stitch. (see page B-83)
The needle will move. Keep your hands etc. away from the
needle area. This message appears when you touch the point closer than 2
cm from the needle drop point with the sensor pen in the
sensor function. (see page B-75)
The pattern extends out of the pattern area, repeat positioning
of center and angle using sensor pen. This message appears when the specified pattern position
extends out of the pattern area. Specify more centered
position of the embroidery frame. (see page B-85)
Marks Error Messages Cause/Solution