Baby Lock Urity BLTY, Instruction And Reference Manual

Page: 302 / 332

ADJUSTING THE THREAD TENSION
E-96
After embroidering trial patterns and checking the results, adjust the thread tensions if necessary. After adjusting the
tensions, be sure to embroider trial patterns again in order to check the results.
■
Adjusting the upper thread tension
We recommend a setting between 6 and 8 for the upper
thread tension when creating bobbin work.
Refer to “Adjusting Thread Tension” on page E-30.
■
Adjusting the tension of the bobbin
thread
If the desired stitching cannot be achieved after
adjusting the upper thread tension, adjust the tension of
the bobbin thread. The tension of the bobbin thread can
be adjusted by turning the slotted-head (–) screw on the
bobbin case (gray) for bobbin work.
a Do not turn the phillips screw (+).
b
Adjust with a small screwdriver.
To increase the tension of the bobbin thread, turn the
slotted-head (–) screw 30° to 45° clockwise.
To decrease the tension of the bobbin thread, turn the
slotted-head (–) screw 30° to 45° counterclockwise.
ADJUSTING THE THREAD TENSION
Note
• Turning the screw on the bobbin case (gray)
may push up the spring plate, as shown
below.
If this occurs, gently press down the spring
plate with a screwdriver so it is lower than
the top surface of the bobbin case (gray),
and then insert the bobbin case into the
machine.
a
Spring plate
CAUTION
• DO NOT adjust the position of the phillips (+)
screw on the bobbin case (gray) as this may result in
damage to the bobbin case, rendering it useless.
• If the slotted-head screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction may
cause damage to the bobbin case. Should damage
occur, the bobbin case may not maintain proper
tension.
Note
• If the bobbin thread tension is tight, the
thread cannot be passed through the
tension spring when the bobbin is installed
in the bobbin case. (Refer to “When tension
is not applied to the bobbin thread” on
page E-91.)