AVYCON H5300 series, User Manual

Page: 51 / 192

51

This page shows information of HDDs installed in the DVR.

When users install full storage device and DVD-RW including one e-SATA storage(C, F, G H, I and J Type), then following
procedures will be listed as below:
-
1. Internal SATA 1~4 Ports
-
2. External SATA 1~4 Ports
-
3. DVD-RW

Under “Information”, it is possible to find the port number where each HDD is connected.
-
For Internal SATA, [P1], [P2], [P3] and [P4] each represents internal Port 1, Port 2, Port 3 and Port 4.
-
For External SATA, [E1], [E2], [E3] and [E4] each represents external Port 1, Port 2, Port 3 and Port 4.

Users must format when:
-
install new HDD
-
add another HDD
-
replace HDD
-
move HDD (change installation port)
-
remove HDD

Use to delete or purge all normal recorded data from database. Please follow the procedure below.
①
Click (

) Clear All Data box.
②
When a Message box asking “All the data will be deleted and cannot be restored. Proceed?” shows, choose ‘OK’ to
confirm.
③
Then, Progress window will display and the process starts.
④
When all data are deleted, a message box “HDD format has been completed.” will pop up.
NOTE
When users add used HDDs from the same type of DVR, users can access data in DVRs as Read-Only or keep
CAUTION
DELETED DATA CANNOT BE RESTORED
.

Please Click (

) S.M.A.R.T and the following screen will display.
S.M.A.R.T

S.M.A.R.T shows the status of HDD connected to the DVR.

Click (

) Refresh box to refresh status of HDDs as the S.M.A.R.T setup.
Notification

A user can set Notification when BAD are detected by S.M.A.R.T.

Check

Alarm out: users can set the alarm out, when “Bad” detects from HDDs. If Click (

) ‘All’, all items are check/uncheck
at once.

Check

Email: users can receive the email notification to registered email address, when Bad detects from HDDs. If Click (

)
‘All’, all items are check/uncheck at once.
HDD Format
S.M.A.R.T