AVYCON H5300 series, User Manual

Page: 27 / 192

27
2.2.4 HDMI connections

Connect HDMI cable to HD out port of rear panel and HDMI port of HD output device.

Please Click (

) SETUP> DEVICE > DISPLAY > General and the following screen will display.

Click the box below to select resolution.
-
A user can select the resolution among ‘1920x1080 (60Hz)’, ‘1920x1080 (50Hz)’, ‘1280x720 (60Hz)’, ‘1280x720 (50Hz)’
and ‘1024x768’.
-
If the resolution is changed then the DVR may restart automatically.
-
The default setting of DVR is ‘1920 x 1080 (60Hz)’.

Click Video Signal box to select signal format.
-
A user can select the signal output among ‘NTSC’, ‘PAL’ and ‘AUTO’.
-
The default setting of DVR is ‘AUTO’
CAUTION
HDMI CONNECTION MAY NOT BE COMPATIBLE WITH CERTAIN OUTPUT DEVICE.
VIDEO NOISE MAY OCCUR DEPENDING ON THE TYPE OF HDMI CABLE USED. MAKE SURE TO USE AN HDMI-CERTIFIED CABLE
.
CAUTION
BLACK SCREEN WILL DISPLAY IF THE MONITOR DOES NOT SUPPORT THE SELECTED RESOLUTION. IN ORDER TO CHANGE
THE RESOLUTION PLEASE PRESS “REW>FF>BACKWARD>FORWARD” IN SERIES USING FRONT BUTTON OR REMOTE
CONTROLLER THEN THE RESOLUTION WILL BE CHANGED TO ‘1024 X 768’.
2.2.5 Audio Connections

Connect an audio device to ‘AUDIO IN’ and a speaker system to ‘AUDIO OUT’. Please use a speaker system with volume
adjustable.
2.2.6 TCP/IP (Ethernet) Connections

Connect to ‘ETHERNET’ connector with the LAN cable.

When connect to Internet, use an ordinary LAN cable (Non-cross cable). However, when connect directly to a PC, please use
only ‘Crossover cable’.
2.2.7 Alarm Connections (TTL)

Connect Alarm Input (Sensor) to ‘AI 1~AI 4 (or AI 16)’ connectors and connect Sensor Common to ‘G’ connector.

Connect Alarm Output (buzzer, siren, etc.) to ‘AO 1~AO 4 (or AO 16)’ connectors and connect Common to ‘G’ connector.
(Except A and B type)