A-Series Dobby Loom Assembly Manual
Bottom Swing Beater
Bottom Swing Beater
Page | 87
b.
Six, seven, or nine (depending upon the width of your loom)
5/16" x 3-1/4"carriage bolts with washers and wing nuts
attached
c.
1/4" x 2-1/4" carriage bolts
3)
Place the shuttle race so that the lengthwise groove is to the top
and is facing toward the rear of the loom. Rest it on the cloth beam
supports between the cloth beam and the harnesses until you
attach the legs.
4)
Take one of the legs and position the small notch at the bottom end
of the leg over the center pin in the beater support. The tapered
side of the leg will face away from the loom. Place it so it is behind
the shuttle race.
Figure 90 - Beater Leg
