18
Un-loading the Fastener from the Module’s Feed System
ü
With staple chain loaded to the Module Assembly per the previous chapter:
Air Supply can be ON
1. Using a spare IndES ejector rod as a tool, hold the ejector rod like a pencil and insert the
long end into the top of the slot in the feed system (Illustration shows right module)
•
A small diameter pin can be substituted in place of an ejector rod
2. Push the ejector rod all the way in until it hits the bottom of the slot
3. Drag the ejector rod down until it contacts the feed systems feed pawl and moves the
pawl out of engagement with the staple chain
4. Hold the pin down and pull up on the staple chain to remove the staple chain from the
feed system
5. Perform the same operation on the other module
Pin
Pin
1,2
3
4
Pin
Summary of Contents for IndES Elastic Staple 11600-0
