![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393025.webp)
23
Changing the Ejector Rod
Turn ON or OFF air supply
1. Remove feed guide screw and feed guide (Illustration shows Right Module)
2. Remove ejector rod from ejector rod slide and then from feed system
3. Insert tip of new ejector rod into ejector rod opening in feed system
4. Insert angled end of ejector rod into ejector rod slide
5. Install feed guide and feed guide screw to hold ejector rod in place
Ejector Rod Slide
Ejector Rod
View of Right Module
Feed Guide
Screw
Feed Guide
Opening in
Feed System
for Ejector Rod
Summary of Contents for IndES Elastic Staple 11600-0
