![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393032.webp)
30
Adjusting the Staple Cut Position
ü
The IndES™ machine’s staple cut position is factory set and should not require
adjustment.
ü
Check and make adjustment after any machine maintenance requiring disassembly or
changing of parts of the Modules.
Turn ON air supply
1. Turn adjustment screw to achieve proper cut position.
2. Cycle machine with air power to verify proper adjustment.
•
Always use locking screw or apply medium strength thread locker to screw
Right Module Cut
Position
Left Module Cut
Position
1t = 0.5mm
Summary of Contents for IndES Elastic Staple 11600-0
