![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393026.webp)
24
Changing the Knife
Turn ON air supply
1. Remove needle block retaining screw, needle block and needle guard
2. Remove knife
3. Select a new right or left knife (Illustration shows Right Module)
4. With the “R” or “L” facing down, position the hole in the knife over the pin extending from
the bottom of the knife slide in the feed system
5. Holding knife in place, reassemble knife block and knife block retaining screw.
6. Ensure knife moves smoothly in and out before tightening needle block retaining screw.
•
If the Knife is not positioned properly in the knife block it will not move in and out
Needle Block
Retaining Screw
1
View looking up from bottom
Needle Block
Knife
Needle Guard
Knife Slide
Knife Slide Pin
Knife
Knife hole
Summary of Contents for IndES Elastic Staple 11600-0
