![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393028.webp)
26
Changing the Feed and Cut Shaft Springs
Turn OFF air supply
1. Remove the feed guide and ejector rod (Illustration shows Right Module)
2. Remove front linkage cover and side cover
3. Remove the feed assembly
•
The feed and cut shaft will extend out the front of the Module
4. The feed and cut shaft spacer and spring can now be removed from the top of the shaft
5. Remove blade drive block screw and blade drive block
6. The blade drive spring can now be removed from the shaft
7. Install new blade drive spring over shaft
8. Reinstall blade drive block and blade drive block screw
•
Push the blade drive block onto the shaft until the end of the shaft is flush with the
bottom surface of the block. The spring will be slightly compressed
•
Be sure to align the holes in the blade drive block and the feed and cut shaft
before inserting the blade drive block screw.
Ejector Rod Slide
Ejector Rod
Feed Guide
Screw
Feed Guide
1
Summary of Contents for IndES Elastic Staple 11600-0
