![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393012.webp)
10
Chapter 4 Adjusting the IndES™ Module
Air Pressure
The IndES™ Module is designed to be operated at 80 PSI [ .55 MPa] 5F
3
/min [.63 M
3
/min]
Increasing the pressure greater than the recommended MAX air pressure may:
•
Cause a dangerous condition to the operator
•
Damage the IndES™ Module
•
Void the manufacturer’s warranty
An air pressure regulator is provided with the IndES™ Module Assembly and is factory set to
the required air pressure. The pressure regulator will reduce the input air pressure to the
recommended operating air pressure. Verify the reading on the air pressure regulator’s dial
which indicates the
operating pressure prior to
operation.
WARNING
MAXIMUM AIR PRESSURE 80 PSI (.55 MPa)
WARNING
Module needles are sharp. Use caution when removing
and replacing needles and during operation.
Discard needles that are damaged or have punctured
the skin
!
!
Air Pressure
Regulator
Summary of Contents for IndES Elastic Staple 11600-0
