![background image](http://html1.mh-extra.com/html/avery-dennison/indes-elastic-staple-11600-0/indes-elastic-staple-11600-0_operation-and-service-manual_3030393022.webp)
20
Installing a Fastener
ü
Position the product between the Module Assembly needles
ü
Make sure the area is clear of everything but the product to be fastened
ü
Lower the IndES™ Module’s needles over the product
ü
Pull the actuation switch located on the handle to install the staple chain around the product
•
Make sure to HOLD the switch until the staple chain is completely installed
ü
Retract the IndES™ Module’s needles from the product
ü
Release the actuation switch. The machine will automatically load the next fastener for use
•
Make sure not to operate the actuation switch again until the machine has completely
reloaded.
•
Premature actuation may cause the machine to jam
WARNING
Air supply must be connected during this procedure.
WARNING
Module needles are sharp. Use caution when removing and
replacing needles and during operation.
Discard needles that are damaged or have punctured the skin
!
!
Actuation Switch
Handle
Module Assembly
Needles
Summary of Contents for IndES Elastic Staple 11600-0
