21
Chapter 6 Maintenance
Routine Maintenance and Lubrication
Daily Maintenance
•
Check for damaged needle tips before beginning operation
•
Blow off machine with air gun at 80psi [5.5 Mpa]
Every 1,000,000 Cycles
•
Replace knives and ejector rods
Every 5,000,000 Cycles
•
Clean and inspect machine components for wear or damage
•
Clean slides and linkage and re-lubricate
Every 10,000,000 Cycles
•
Replace Blade Drive Spring
•
Replace Feed and Cut Shaft Spring
•
Replace Feed Pawl
•
Replace Feed Links and Feed Link Pivots
Recommended Lubricant
High quality Moly EP grease
WARNING
Always use caution when air supply is connected
WARNING
Module needles are sharp. Use caution when removing and
replacing needles and during operation.
Discard needles that are damaged or have punctured the skin
!
!
Summary of Contents for IndES Elastic Staple 11600-0
