11
Module Needle Depth
To properly install fasteners, the Module’s needles must be adjusted so the opening in the
end of the needle is below the top surface of the base.
1. Loosen the bottom stop on the LMS
2. Lower the Module until the Needle guards expose the Needles so that the guards
are touching the top of the Brush Block
3. Position the stop to the bottom of the Module Assembly
4. Tighten the stop adjustment screw
WARNING
Disconnect air supply before making this adjustment
WARNING
Module needles are sharp. Use caution when removing and
replacing needles and during operation.
Discard needles that are damaged or have punctured the skin
!
!
1
Needle
Guard
Needle
Brush
Block
1
LMS bottom
stop
Brush Block
Summary of Contents for IndES Elastic Staple 11600-0
